Vesta "Juno" VS Treadle

This is one of the smoothest machines I've ever owned. Cosmetically it's gorgeous, too.

VestaFront

The machine has a full-size bed, although the body is comparable to a 3/4-size machine. The extra length is to the left of the slide plates.

VestaOpen

The treadle cabinet has a wooden treadle (pedal) with a brass front edge, very pretty. There's a metal protruberance on the left inside, about halfway up from the treadle, maybe a footrest? 

The extension table doubles as the table top when the machine is stored in the down position:

VestaCabClosed

That extension/table top hangs from clips on the side, and is supported by an iron swing-out arm. Note that this iron arm is from another machine (a Singer 31-15, I think) because the original was broken off.

VestaExtUp

An interesting cabinet detail is the tray inside, which has a sliding door shown open in the picture below. If this were a round-bobbin machine, I'd assume this was for access to change the bobbin without disengaging the belt to tilt the machine back. But it's a VS machine. Maybe the cabinet was made to accommodate different machines?

VestaDoorOpen

The drawer is decorated with pretty veneer-work on the outside:

VestaCabinetDetail

Veneer-work on the lip of the drawer with a ruler in both inches and centimeters:

VestaRuler

A number of feet and spare parts, and the key for the top. Feet are stamped "LOD" for L.O. Dietrich, the manufacturer.

VestaFeet

The top is hinged to fold the machine down into the cabinet:

VestaFoldingMech

The machine is obviously a Vesta "Juno" model, made by L.O. Dietrich in Altenburg. The Altenburg reference identifies it as post-1948, when the company moved there. I don't know for sure, but would guess this is a 1950s machine.

VestaPillar

The serial number is 0 1847855 6, with the initial "0" and concluding "6" being in small-size and subscript. Don't know what the significance is of that.

VestaSerNo

The back:

VestaBack

Handwheel is interesting. Rather than radiating spokes, they are grouped in pairs, north, south, east, and west:

VestaHW

The faceplate has the same patterning as the clutch knob and rear inspection plate. This type of pattern is similar to those on Pfaff machines I've owned. A German thing?

VestaFaceplate

Inside the pillar, the dealer label, I believe: Friedrich Meier, sewing machine specialist, Furth.

VestaMeierCU

If you're interested in purchasing this machine, please contact McKenna.

VestaExtUp

copyrightfile:///Users/mckennalinn/Machines/Singer29K51/Singer29K51FootSideways.JPG McKenna Linn, 2008, all rights reserved